LPC2138 I2C DRIVER

These simulation capabilities are described below. How do i check whether an I2C device works? Unlike SPI this protocol only uses two wires to establish the connection and hence known as Two wire interface. Dialog boxes which display and allow you to change peripheral configuration. Amplifier Yamaha RX-V not turning on

Uploader: Shahn
Date Added: 21 July 2004
File Size: 34.46 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 81236
Price: Free* [*Free Regsitration Required]

Usually the communication begins with start condition followed by the slave address of the slave and then comes the data.

I don’t understand where I went wrong. Frank van Eijkelenburg, Jun 28, Device Address contains the slave device address. Video games, blogging and programming are the things he loves most.

Why isn’t a Device Listed?

Peripheral Simulation

SI Interrupt is set to indicate a state change in the I2C controller. If it ran in the simulator and doesn’t run on hardware, double check that your hardware is correct.

LPC I2C working example? This lpd2138 is only valid in Slave mode. This sample code gives you an idea of programming I2C and transmitting bytes of data in master mode and the slave controller retrieves it and displays it in its Port1. So, the controller will be able to support lights all together in 10 rows.

  APACER HANDY STENO HT202 DRIVER

LPC I2C c – Free Open Source Codes –

How can the power consumption for computing be reduced for energy harvesting? This code was built using Keil uVision 4.

Each row will be extended by each light module panel in which each panel support 10 LED lights — maximum lc2138 such module panels in each row. Such names are reserved for the implementation and shall not be used by an application. Frank Donald is an Electronics and Communication Engineer who loves building stuff in his free time. Unlike SPI this protocol only uses two wires to establish the connection and hence known as Two wire interface. Discussion in ‘Embedded’ started by Frank van Eijkelenburg, Jun 18, I actually simulated the code using Proteus.

These simulation capabilities are described below. Frank van Eijkelenburg, Jun 26, Can someone please help? Stack Overflow works best with JavaScript enabled.

Post as a guest Name.

Radiation Detection Circuit 1. Hi, I am still using the LPC This register holds the data to be transmitted or received. Dialog boxes which display and allow you to change peripheral configuration.

  IRIVER E200 USB DRIVER

Receive or transmit data based on the direction bit received along with the slave address. Ultrasonic transducer driver 1. After that, you can post your question and our members will help you out.

Frank Donald January 11, 3 Comments. How to upload a counter value to a website automatically 3. Let me briefly explain my mini project. The following groups control the simulation of the I2C Interfaces:.

GC is set to respond to a General Call address 0x